Kitchen Appliances · Revised 2026-10-16
Hot-and-Iced Coffee Maker Fit: Tastyle K330CH Counter Check
Check the K330CH body dimensions, open-lid space, reservoir path and travel mug before choosing a hot-and-iced coffee maker for a small counter.
Short answer: A hot-and-iced coffee maker can suit a small counter when you have room to open it, refill it and remove your usual mug. For the white Tastyle K330CH listing, start with the stated 4.7-inch width, 10.3-inch depth and 12.2-inch height, then check the operating space separately. Our buying judgment: keep this model on the shortlist only if those movements work in your kitchen; the closed-body dimensions alone do not establish a fit.
What we can tie to this particular machine
The US listing for ASIN B0DQDLLGYP identifies the white K330CH. It states a removable 40 oz reservoir, pod or ground-coffee brewing, a magnetic organizer and a 7.3-inch mug fit. Those are retailer-published specifications, not measurements we made. The original dimensions are written as 10.3"D × 4.7"W × 12.2"H; keep those axes when sketching the counter.
We have not authenticated a manufacturer instruction manual for this exact K330CH revision. Similar Tastyle names are not enough to transfer a lid clearance, cleaning cycle or descaling recipe. The numbers above screen a candidate; they do not settle installation or drink quality.
Draw the refill and mug paths, not just a rectangle
Our space check below is an editorial worksheet. Fill it with measurements from your counter and the exact machine or its matched instructions. A blank is a question to resolve before ordering, rather than extra clearance we can safely invent.
| Part of the routine | Write down | What would stop this setup |
|---|---|---|
| Machine on the counter | Your available width and depth; compare with the listing dimensions above. | The organizer or nearby appliances leave no usable access. We do not have a separate organizer-inclusive footprint. |
| Opening the brewer | Cabinet underside height and confirmed open-lid height. | You cannot load the holder without moving the machine. The listing's closed height does not answer this. |
| Refilling | The route to remove and replace the reservoir, or access to fill it as the matched manual permits. | The tank catches a shelf or cannot be handled comfortably at the planned location. |
| Removing the drink | Your mug's actual height, handle and lid arrangement; the tray position used for the fit claim. | A nominally short enough mug still cannot be lifted or slid out. The quoted mug height does not describe every handle or lid. |
| After brewing | Where the used pod or grounds go and where removable parts will be washed and dried. | The machine fits, but the cleanup routine takes over the remaining preparation surface. |
A cardboard outline can help you check the plan, but it cannot verify an unknown open-lid height. Our preference for a cramped counter is to resolve that missing measurement before choosing extra drink modes.
Check what “iced” asks you to do
The listing names HOT BREW, BOLD and OVER ICE modes. It does not give us a verified brew-temperature trace, finished-drink temperature or taste comparison. Treat the mode names as controls to investigate, rather than evidence that the machine cold-brews coffee.
For your usual iced drink, find the exact instructions for ice, water and a suitable vessel. Check whether the marked brew amount describes water dispensed or the finished drink with ice. We are leaving those answers open for K330CH because an unverified recipe could give you the wrong serving size.
Put a cost against the routine you will use
Compare pods and grounds using your own purchases. For pods, coffee cost per drink = pack price ÷ usable pods in the pack × pods used per drink. For grounds, coffee cost per drink = bag price ÷ bag weight in grams × grams used per drink. Use a consistent currency; the prices, pack count and bag weight come from your receipt or label, and the amount used comes from your matched brewing instructions or your recorded recipe. These are calculations, not a Tastyle performance test.
Add milk, water or ice costs only when they matter to your comparison. Record the actual price of any replacement holder or approved descaler separately. We cannot give a maintenance interval or energy bill for this exact revision from the evidence available.
Offer and source checks
The current K330CH listing is the source for the model and dimensions quoted here. Confirm that the selected color, accessories and model still match before buying. A current feed quote, when available below, is a separate price observation; it does not verify clearance or brewing results.
Latest feed quotes
- Tastyle Hot & Iced Coffee Maker with Magnetic K-Pod Holder, Fits 7.3'' Mug (B0DQDLLGYP): Latest feed quote (PartnerBoost) — $59.98 USD. Feed checked Oct 16, 2026 08:30 UTC+08; supplier update date 2026-10-15.
US affiliate-feed records, not guaranteed checkout prices. These quotes do not replace the dated prices, tests or judgments in the article.
Frequently asked questions
Does a 4.7-inch width establish that the K330CH fits my counter?
No. It is the listing's body-width figure. Open-lid access, the reservoir path, organizer space and mug removal still need checking.
Is the 7.3-inch mug claim enough to choose a travel cup?
No. Confirm the tray arrangement and measure your cup with the handle and lid you will use. We have not measured this machine's removal path.
Can I use another Tastyle model's descaling instructions?
Do not transfer a recipe or button sequence from a different model. Use instructions matched to the K330CH revision you receive.
The detail that would change our decision
Get the open-lid measurement and reservoir-removal path for the exact unit. If that requires moving a hot, filled machine every morning, our buying judgment is to choose a setup you can operate where it stands. A drink-mode label cannot resolve that handling problem.